@Lat_Long wrote:
Hello all,
I'm making the switch from APM 2.x to Pixhawk and I have a question about wiring.
As I understand it the power supply to the pixhawk board does not power the output rail?
So I have a 3DR module to power the Pixhawk. Then I have a BEC 5.7v powering the output rail. The ESC servo cable has the (+) cable disconnected. The ESC is powered from the back of the 3DR power module. The 3DR power module and the BEC are power from separate batteries, All components are connected via the (-).
Can anyone see a problem with the above setup?
Thanks in advance,
Richard
Posts: 8
Participants: 2